Buildings.Fluid.HeatPumps.Data.EquationFitReversible.BaseClasses

Base classes for package Data

Information

This package contains the common parameters that are used to specify the heat pump models in Buildings.Fluid.HeatPumps.Data.EquationFitReversible.

Extends from Modelica.Icons.BasesPackage (Icon for packages containing base classes).

Package Content

Name Description
Buildings.Fluid.HeatPumps.Data.EquationFitReversible.BaseClasses.HeatingCoolingData HeatingCoolingData Record for performance data that are used for heating and cooling separately

Buildings.Fluid.HeatPumps.Data.EquationFitReversible.BaseClasses.HeatingCoolingData

Record for performance data that are used for heating and cooling separately

Information

Performance data for the heating or cooling mode of the reverse heat pump Buildings.Fluid.HeatPumps.EquationFitReversible.

Parameters

TypeNameDefaultDescription
MassFlowRatemLoa_flow Nominal mass flow rate at load heat exchanger side [kg/s]
MassFlowRatemSou_flow Nominal mass flow rate at source heat exchanger side [kg/s]
Nominal conditions at load heat exchanger side
HeatFlowRateQ_flow Nominal capacity [W]
PowerP Nominal compressor power [W]
Performance coefficients
RealcoeQ[5] Load ratio coefficients
Electrical power performance coefficients
RealcoeP[5] Power ratio coefficients
Reference conditions
TemperatureTRefLoa Reference temperature used to normalize the load heat exchanger inlet water temperature [K]
TemperatureTRefSou Reference temperature used to normalize the source heat exchanger inlet water temperature [K]

Modelica definition

record HeatingCoolingData "Record for performance data that are used for heating and cooling separately" parameter Modelica.Units.SI.HeatFlowRate Q_flow "Nominal capacity"; parameter Modelica.Units.SI.Power P "Nominal compressor power"; parameter Modelica.Units.SI.MassFlowRate mLoa_flow "Nominal mass flow rate at load heat exchanger side"; parameter Modelica.Units.SI.MassFlowRate mSou_flow "Nominal mass flow rate at source heat exchanger side"; parameter Real coeQ[5] "Load ratio coefficients"; parameter Real coeP[5] "Power ratio coefficients"; parameter Modelica.Units.SI.Temperature TRefLoa "Reference temperature used to normalize the load heat exchanger inlet water temperature"; parameter Modelica.Units.SI.Temperature TRefSou "Reference temperature used to normalize the source heat exchanger inlet water temperature"; end HeatingCoolingData;