02346nas a2200229 4500008004100000245009900041210006900140490000800209520158400217653003601801653001301837653002001850653001801870653001501888653003001903100002001933700001501953700001901968700002001987700002102007856008802028 2018 eng d00aA Novel Variable Refrigerant Flow (VRF) Heat Recovery System Model: Development and Validation0 aNovel Variable Refrigerant Flow VRF Heat Recovery System Model D0 v1683 a
As one of the latest emerging HVAC technologies, the Variable Refrigerant Flow (VRF) system with heat recovery (HR) configurations has obtained extensive attention from both the academia and industry. Compared with the conventional VRF systems with heat pump (HP) configurations, VRF-HR is capable of recovering heat from cooling zones to heating zones and providing simultaneous cooling and heating operations. This can further lead to substantial energy saving potential and more flexible zonal control. In this paper, a novel model is developed to simulate the energy performance of VRF-HR systems. It adheres to a more physics-based development with the ability to simulate the refrigerant loop performance and consider the dynamics of more operational parameters, which is essential for representing more advanced control logics. Another key feature of the model is the introduction of component-level curves for indoor units and outdoor units instead of overall performance curves for the entire system, and thus it requires much fewer user-specified performance curves as model inputs. The validation study shows good agreements between the simulated energy use from the new VRF-HR model and the laboratory measurement data across all operational modes at sub-hourly time steps. The model has been adopted in the official release of the EnergyPlus simulation program since Version 8.6, which enables more accurate and robust assessments of VRF-HR systems to support their applications in energy retrofit of existing buildings or design of zero-net-energy buildings.
10abuilding performance simulation10acontrols10aenergy modeling10aheat recovery10avalidation10aVariable refrigerant flow1 aZhang, Rongpeng1 aSun, Kaiyu1 aHong, Tianzhen1 aYura, Yoshinori1 aHinokuma, Ryohei uhttps://simulationresearch.lbl.gov/publications/novel-variable-refrigerant-flow-vrf02607nas a2200169 4500008003900000245006200039210006000101520204900161100001902210700001802229700001902247700001702266700002302283700002002306700002102326856009002347 2014 d00aA New Model to Simulate Energy Performance of VRF Systems0 aNew Model to Simulate Energy Performance of VRF Systems3 aThis paper presents a new model to simulate energy performance of variable refrigerant flow (VRF) systems in heat pump operation mode (either cooling or heating is provided but not simultaneously). The main improvement of the new model is the introduction of the evaporating and condensing temperature in the indoor and outdoor unit capacity modifier functions. The independent variables in the capacity modifier functions of the existing VRF model in EnergyPlus are mainly room wet-bulb temperature and outdoor dry-bulb temperature in cooling mode and room dry-bulb temperature and outdoor wet-bulb temperature in heating mode. The new approach allows compliance with different specifications of each indoor unit so that the modeling accuracy is improved. The new VRF model was implemented in a custom version of EnergyPlus 7.2. This paper first describes the algorithm for the new VRF model, which is then used to simulate the energy performance of a VRF system in a Prototype House in California that complies with the requirements of Title 24 – the California Building Energy Efficiency Standards. The VRF system performance is then compared with three other types of HVAC systems: the Title 24-2005 Baseline system, the traditional High Efficiency system, and the EnergyStar Heat Pump system in three typical California climates: Sunnyvale, Pasadena and Fresno. Calculated energy savings from the VRF systems are significant. The HVAC site energy savings range from 51 to 85%, while the TDV (Time Dependent Valuation) energy savings range from 31 to 66% compared to the Title 24 Baseline Systems across the three climates. The largest energy savings are in Fresno climate followed by Sunnyvale and Pasadena. The paper discusses various characteristics of the VRF systems contributing to the energy savings. It should be noted that these savings are calculated using the Title 24 prototype House D under standard operating conditions. Actual performance of the VRF systems for real houses under real operating conditions will vary.
1 aHong, Tianzhen1 aPang, Xiufeng1 aSchetrit, Oren1 aWang, Liping1 aKasahara, Shinichi1 aYura, Yoshinori1 aHinokuma, Ryohei uhttps://simulationresearch.lbl.gov/publications/new-model-simulate-energy-performance