3.2. Installation
Prev Chapter 3. Installation and configuration Next

Search

Building Controls Virtual Test Bed > Installation and configuration > Installation

3.2. Installation

To install the BCVTB, follow these steps:

  1. Download the installation file bcvtb-install-os-x.y.z.jar from the download page, where os denotes the version of the operating system and x.y.z denotes the latest version number.
  2. Run the installation program bcvtb-install-os-x.y.z.jar.
  3. Depending on your installation, you may need to set system environment variables as described in Section 3.3, “Setting system environment variables”.
  4. Test the installation by running an example as described in Chapter 4, Running simulations with the BCVTB.

[Note]Note

This manual assumes that the BCVTB is installed in a directory called bcvtb. However, the BCVTB may be installed in any directory. (To run the examples provided with the BCVTB, write permission are required for the directory bcvtb/examples.)

Prev Up Next
Chapter 3. Installation and configuration Home 3.3. Setting system environment variables